![]() Newer-style fill valves have a plastic float that slides up and down the outside of the fill valve.Tip: You may want to bend the float rod down a bit and then make another bend so that the float is not pointed downward but is relatively parallel to the water’s surface.Be sure when you reinstall the rod and float that the bend you have just made has lowered the float slightly. If it is difficult to bend the rod while it is inside the tank, you can unscrew the rod from the valve, bend the rod, and then replace it. Tip: Before bending the rod, make sure the rod and float are hand-tightened so that they will not rotate and thus eliminate the effectiveness of the bend in the rod.If there is no adjustment mechanism or you can’t find it, you can adjust the water level by slightly bending the float rod down with your hands, thus forcing the valve to close with the water at a lower level. If there is a water level adjustment screw on the top of the fill valve, you can lower the water level by turning it.If the water level is above the overflow pipe, the valve cannot totally shut off. As the water level in the tank rises, the float and attached rod gradually close the fill valve until it is turned off.The float is about 2.5 inches in diameter and 3.5 inches long and is rounded on each end. A plastic or metal cylindrical float is attached to the end of the rod. Older-style fill valves have a threaded rod about six or eight inches long attached near the top of the fill valve.Usually, you can adjust the amount of water in a toilet tank in one of two ways. If this is the case, water is probably trickling down the overflow pipe and into the toilet bowl. You can tell by touch if the water level is above or near the top end of the overflow pipe. ![]() Please note that this guide does not address repairs when water leaks onto the floor from the tank or at the floor level. The flapper or stopper ball that closes off the outlet at the bottom of the tank may be defective.Īny of these problems can be repaired by someone who is blind or low vision by having the right tools, correct replacement parts, and the correct sequence of steps.The water level in the tank may be at or above the top of the overflow pipe. ![]() Usually, this is caused by one of the following problems: ![]() This uses water needlessly and can be startling if it occurs during the night when the sound of the tank refilling may awaken you. Over time, toilets may leak small amounts of water from the tank into the toilet bowl, causing more water to be added. Fixing Toilets That Do Not Shut Off Properly ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |